Product image


  • Product image

HID V100 Door\Reader Interface


  • The V100 Door / Reader Interface connects two access control card readers via Wiegand or Clock-and-Data interface controlling either one or two doors.
  • The V100 features on-board flash memory, allowing program updates to be downloaded via the network. The V100 connects to the V1000 through a high speed RS-485 network.
  • The V1000, in turn, communicates with the system host via industry standard TCP/IP protocol over 10/100 Mbps Ethernet or the Internet. This architecture minimizes the impact on corporate LANs by using only one TCP/IP address for every 32 interfaces and by handling low-level transactions on the RS-485 network.
  • The HID VertX® products provide a complete and fully featured hardware/firmware infrastructure for access control software host systems.

Key Benefits

  • Reports supervised inputs.
  • Connects to the V1000 via RS-485.
  • Receives and processes real time commands from the V1000.
  • Reports all activity to the V1000.
  • Attractive polycarbonate enclosure protects components from damage.
  • All connections and indicators are fully identified by silk-screened nomenclature on the cover.
  • Processes off-line access control decisions based on facility code.
  • UL 294 and UL 1076 recognized components.


VertX V100 Door/Reader Interface Datasheet


Power Supply Requirements

- 60 mA @ 9-18 VDC (with no readers connected) Recommended: Supervised linear power supply with battery backup, input surge protection, and AC fail and battery low contact outputs
- When VertX is supplying power to readers the requirements are 600 mA @ 9-18VDC. The V100 can supply 500 mA to two readers


5.8" W x 4.825" H x 1.275" D (147.32 mm x 122.55 mm x 32.38 mm)
12.4 oz (.35 kg)


- RS-485 - 4000 feet (1220 m) to host, using Belden 3105A, 22AWG twisted pair, shielded 100? cable Wiegand - 500 feet (150 m) to reader - using ALPHA 1299C 22AWG, 9-conductor, stranded, overall shield (Fewer conductors needed if all control lines are not used).
- Input Circuits - 500 feet (150 m), 2-conductor, shielded, using ALPHA 1292C (22AWG) or Alpha 2421C (18AWG)
- Output Circuits - 500 feet (150 m), 2-conductor, usingALPHA 1172C (22AWG) or Alpha 1897C (18AWG) Minimum wire gauge depends on cable length and current requirements.

Operating Environment

32 ° đến 122 ° F (0 ° đến 50 ° C)


UL 294 and UL 1076 Recognized Component for the US
CSA 205 for Canada
FCC Class A Verification
EMC for Canada, EU (CE Mark), Australia (C-Tick Mark),
New Zealand, Japan
EN 50130-4 Access Control Systems Immunity for the EU (CE Mark)


Reviews and comments of: HID V100 Door\Reader Interface

4.2 out of 5 rate
review star
11 reviews

1 star
2 star
3 star
4 star
5 star


You're reviewing: HID V100 Door\Reader Interface



We’ll help you learn everything you need to know about ID card systems, access control systems from how the itemts work to important advice when setting up a new system, card templates, case studies, and more.